How to prepare our milk from powder
Our easy-to-follow guide shows you how to prepare a bottlefeed safely using our powder formula or watch our detailed video below.
|Wash and sterilise bottles and teats according to manufacturer’s instructions. Wash your hands and wipe clean all surfaces to prevent the spread of germs.|
|Boil freshly run tap water and leave to cool for 30 mins, unless otherwise indicated on pack. Measure required amount of water (refer to on-pack instructions) into a sterilised bottle. Do not use repeatedly boiled water.|
|For accurate dosage, always use scoop provided and level off powder with built-in leveller (if provided). Alternatively, level with a clean, dry knife. Do not press extra powder into scoop.|
|Add correct measure of powder to water. Adding too many or too few scoops can be harmful. The feeding instructions on the pack will give you an indication of the number of feeds your baby may need per day.|
|Screw cap on bottle and shake well for 10 seconds to dissolve powder in water. If necessary, cool feed under cold running water. Remove seal and replace with sterilised teat. Test temperature of milk by allowing some drops to fall on your wrist. If it feels comfortable, it should be just right for your baby. Do not heat feeds in a microwave as hot spots can occur and cause scalding.|
|Use made-up feeds within two hours. Once used, discard any leftover milk, wash bottles and teats, and re-sterilise, ready for next feed.|